For the deviation of size and for the deviations of the geometrical characteristics (form, orientation and location) the function of the part requires limitations which, when exceeded, impair this function. Introduction All features on component parts always have a size and a geometrical shape. Ii COPYRIGHT 2003 International Organization for Standardization
International Organization for Standardization Case postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland No part of this publication may be reproduced or-utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. Parts, under the general title General tolerances :Īnnex A of this part of IS0 2768 is for information With IS0 2769-2 : 1999, cancel and replace They are approved in accordance with IS0 procedures requiring at least 75 % approval by the member bodies voting. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the IS0 Council. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. The work of preparing International Standards is normally carried out through IS0 technical committees. Partie 1 : Tolhrances pour tolhances individuellesĬOPYRIGHT 2003 International Organization for Standardizationĭocument provided by IHS Licensee=Deere & Co/9999663100, User=, 00:02:20 MST Questions or comments about this message: please call the Document Policy Management Group at 1-80.įoreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies).
Part 1: Tolerances for linear and angular individual tolerance indications
0 kommentar(er)
